Publicidad
Idiomas disponibles
Idiomas disponibles
Special Installation Instructionsfor Australia and New Zealand.
Installingthe WaterLine(cont.)
Connecting the Tubing to the Shutoff Valve
Attach
the fitting
with the male
thread
supplied
with the water
supply
kit to the shutoffvalve
(or
pressure
limiting
valve, if fitted),
and
tighten.
NOTE: PTFE tape
should
be used for a water tight
seal when
assembling
all the above
fittings.
Route
the tubing
through
a hole
drilled
in the side
of the cupboard
as close
to the wall as possible.
Make sure there is sufficient
length of tubing
[approximately
240 cm coiled into 3 turns of
approximately
25 cm] to allow the refrigerator
to move out from the wall after installation.
Insert
and push
the end
of the tubing
into
the
fitting
as tar as possible.
_]th
the fl'ee end
of the tubing
located
in a
suitable
container,
turn
the main
water supply
On and
flush out the tubing
tmtil the water
is clear.
Turn
Off the shutott
valve atier
approximately
1 litre
of water has been
flushed
through
the tubing.
Connecting the Tubing to the Refrigerator
Before making the connection to the refrigerator, be
sure the power is turned OFFand the power cord is
disconnected from the Power Outlet.
If your
refl'igerator
does
not
include
a water
filter,
we recommend
installing
one
in the
water
line
near
the
reli'igerator
if vom"
water
supply
has
sand
or particles
that
could
clog
the
screen
of the
refl'igerator's
water
valve.
Reiilove
the
reflJgei'ator
access
cover.
Remove
the
plastic
flexible
cap
from
the
water
valve
(reti'igera
tot
connection).
Attach
the fitting
with the female
thread
supplied
with the water
supply
kit to the water
wflve and
tighten,
Insert
and push
the end
of the tubing
into
the
fitting
as tar as possible.
Fasten
the tubing
into
the clamp
provided
to hold
it in position.
You may need
to pry open
the clamp.
36
Publicidad
