Connecting A Vcr; Connecting An S-Vhs Vcr - Samsung LN-S2641D Manual Del Usuario

Ocultar thumbs Ver también para LN-S2641D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions on
pages 7-8). Skip step 1 if you have not yet connected to an antenna or a cable system.
VCR Rear Panel
5
2
4
3
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
Each external input source device has a different back panel configuration.
When connecting an external device, match the color of the connection terminal to the cable.
For 40 inch model, use the cables with the ferrite core.

Connecting an S-VHS VCR

Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR.
(This connection delivers a better picture as compared to a standard VHS VCR.)
VCR Rear Panel
3
2
1
An S-Video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)
Each external input source device has a different back panel configuration.
When connecting an external device, match the color of the connection terminal to the cable.
For 40 inch model, use the cables with the ferrite core.
ANT 1 IN
(AIR)
Audio Cable (Not supplied)
Video Cable (Not supplied)
RF Cable (Not supplied)
Audio Cable (Not supplied)
S-Video Cable (Not supplied)
RF Cable (Not supplied)
ANT 2 IN
(CABLE)
TV Rear Panel
TV Rear Panel
English-9
1. Unplug the cable or antenna
from the back of the TV.
2. Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
3. Connect an RF Cable
between the ANT OUT
terminal on the VCR and the
ANT 1 IN (AIR) or ANT 2 IN
(CABLE) terminal on the TV.
4. Connect a Video Cable
between the VIDEO OUT jack
on the VCR and the AV IN 1
[VIDEO] jack on the TV.
5. Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN 1 [R-AUDIO-L] jacks
on the TV.
If you have a "mono"
(non-stereo) VCR, use a
Y-connector (not supplied) to
hook up to the right and left
audio input jacks of the TV.
If your VCR is stereo, you
must connect two cables.
1. To begin, follow steps 1–3
in the previous section to
connect the antenna or
cable to your VCR and
your TV.
2. Connect an S-Video Cable
between the S-VIDEO OUT
jack on the VCR and the
AV IN1 [S-VIDEO] jack on
the TV.
3. Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN1 [R-AUDIO-L] jacks
on the TV.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ln-s3241dLn-s4041d

Tabla de contenido