Motor Parameter Settings (3300A Feedpar) - Atlanta Attachment Company 3200PB1 Manual Del Usuario

Motor Parameter Settings
Before Programming, Perform a Master Reset of Parameters (See Below)
PARAMETER RANGE
290
110 70-390
111
119
153
161
207
220
240
270
272 020-255
436
401
Front panel LED's:
LED 1: Off
LED 2: Off
LED 3: Off
LED 4: Off
LED 5: Off
LED 6: Off
LED 7: Off, Stop at needle down.
LED 8: Off
Speed
Fast
Slow
(3300A FeedPAR)
VALUE
0
70
0-999 120
1-3 1
0-50 35
0-1 1-CCW
1-55 35
1-55 1
0-56 55
0-5 5
100
0
0-1 1
RPM Treadle/Low
151 C
28 B&C
Mode of operation. MUST SET THIS PARAMETER FIRST!
Positioning speed = 700 rpm
Maximum speed = 1200 rpm.
Linear acceleration
Braking power at standstill
Motor rotation
Braking
Acceleration
Enable reverse run of motor with input 1
No handwheel sensor
Drive ratio between motor pulley and handwheel pulley. If handwheel
pulley is smaller than motor pulley, increase this value to slow down
sewing head until measured speed matches speed set with
parameter 111.
Use code "5913". This disables an input that was causing box to
reset itself.
Immediate save all parameters before turning off power
Programming Instructions:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "311"
3. Press "E" once and "2.0.0." is displayed this is a parameter
4. Proceed to the parameter to be changed and press "E"
5. The value now shows in the screen, adjust to desired value.
6. Press "E" to enter value and continue with parameter setting.
7. Repeat for other parameters, press "P" once when complete.
8. Run sewing head to save parameters before powering down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "591"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
Technical Manual & Parts Lists
DESCRIPTION
18