Noritsu Koki IP-64 Manual De Instrucciones página 46

To shorten the length of the blue paper
holder for the left side of the roll
Pinch the two
buttons inward.
Turn this round part fully
counterclockwise.
Push this round part
upward.
46
Loading the Paper Roll and Ink Ribbon
And then, push
this round part
downward.
v
v
Confirm that the arrow
on the shaft of the blue
paper holder is aligned
with the arrow for
R153/R155 on the
label.
Paper with 152-mm (6-inch) width: 2YNR-
R154 and 2YNR-R156 Printing Pack
Extend the length of the blue paper holder.
Extend the length of the blue paper holder
following the reverse of the operation used for
shortening its length.
5
Insert the blue paper holder inside the paper roll as
illustrated.
6
Place the paper upside down and attach the pink
paper holder as illustrated.
Confirm that the arrow
on the shaft of the blue
paper holder is aligned
with the arrow for
R154/R156 on the
label.
Insert this blue paper holder
into the side to which the
blue tape is attached.
To remove the blue tape from
the cut on the tape, tear and
pull the blue tape after
attaching the paper holders.
A part of the tape remains
inside the case of the paper
roll.