HIKOKI UR 18DSDL Instrucciones De Manejo página 11

10. Press the Select button to set up repeat.
Once
Daily
Weekdays only
Saturday and Sunday only
Daily
11. Press the Enter / Information button to complete setup.
will be displayed on the LCD.
○ To cancel the alarm setting, go to "
again and change the setting to "
○ The alarm sound will automatically switch off after 10
minutes. The sound can also be switched off by pressing
any button.
NOTE
The volume of the buzzer alarm cannot be changed.
● Setting the radio ON alarm timer
Using the radio ON alarm timer function, the radio can be
set up to switch ON at a specifi c time to enjoy a station
broadcast.
1. Press the Menu button.
2. Press the Select button and display "
Radio alarm
3. Press the Enter / Information button.
4. Press the Select button and display "
ON
5. Press the Enter / Information button.
6. Press the Select button and adjust "hour" digits.
12 : 00
7. Press the Enter / Information button.
8. Press the Select button and adjust "minute" digits.
12 : 55
9. Press the Enter / Information button.
10. Press the Select button to set up repeat.
Once
Daily
Weekdays only
Saturday and Sunday only
Daily
11. Press the Enter / Information button.
12. Select radio bandwidth.
Press the Select button to display "DAB", "AM" or "FM".
FM
13. Press the Enter / Information button.
14. Press the Select button to display a preset station.
To select a station by broadcast frequency, use the
Search button.
15. Press the Enter / Information button to complete setup.
○ To cancel the radio alarm setting, go to "
" once
once again and change the setting to "
" .
NOTE
The radio's volume will be at the level when the radio
was last switched OFF.
RECHARGING YOUR SMARTPHONE
Devices such as a smartphone and mobile phone can be
recharged by connecting the device to this radio.
The recharge function is only available for the "
"
in "
NOTE
○ When recharging in "
".
volume output at 20 or less.
The radio is designed to deactivate USB output and
disable the recharging of smartphones and mobile
phones when the volume is at 21 or more.
(For "
even if the volume output is 21 or more.)
○ On rare occasions, sound output may be interrupted or
".
power could shutdown during USB recharging.
If either should occur, lower the volume level or stop
recharging with the USB.
○ The radio is designed to deactivate USB output and
disable the recharging of smartphones and mobile
phones when the power level of the battery is low.
Should the aforementioned occur, recharge the battery
or replace with a fully charged battery.
○ If the voltage is low when the AC adapter is in use, the
USB output may be cut off , discontinuing any recharging.
1. Using a commercially available USB connection/
recharge cable, connect to the USB charging port
located in the radio's storage case for external devices.
(Fig. 9)
2. Secure the smartphone with the holders and close the
cover. (Fig. 8)
(See "Secure the external device" on page 9)
NOTE
○ Use a fully charged battery when using a battery as this
device's power source.
You will not be able to recharge smartphones or mobile
phones when the battery power level becomes low.
○ The time required for charging varies in accordance with
the smartphone or mobile phone being recharged.
○ Do not use the recharge function for any devices other
than a smartphone or mobile phone.
○ The radio may not be able to recharge some smartphone
or mobile phone models.
Two recharge cable holders, one for Android and the other
for Apple (Lightning connector) are included.
Select the holder that best suits your device.
○ Should your device be too large for the radio's external
device storage case, draw the cable through the cable
access hole. (Fig. 10)
11
P2 FM 79.5 MHz
FM 80.0 MHz
will be displayed on the LCD.
" or " " mode. (Recharging cannot be done
" mode.)
" or "Bluetooth" mode, set the
" or " " mode, USB recharging will continue
English
"
".
", " ",