Muse M-199 DAB Manual De Instrucciones página 8

GB DAB+/FM CAR RADIO WITH BLUETOOTH & USB/SD
PRECAUTIONS
1. Do not attempt to modify the unit, modifying the unit may cause an accident.
2. Installation or servicing of the unit by persons without training and experience in electronic
equipment and automotive accessories may be dangerous and could expose you to the risk
of electric shock or other hazards.
3. Stop the vehicle before carrying out any operation that could interfere with your driving.
4. Keep the volume at a level which you could hear sounds from outside the vehicle.
5. Do not work in extremely high or low temperature. Be sure the temperature inside the vehicle
is between +60°C and -10°C before turning on your unit.
6. When replacing the fuse(s), the replacement must be of the same amperage as shown on
the fuse holder.
7. Do not block vents or radiator panels. Blocking them will cause heat to build up inside and
may result in fire.
8. Using this unit without running the engine can result in battery drainage.
9. Use only in cars with a 12 volt negative ground.
10. After completing the installation or replacing the car battery, you need to reset the unit before
using it. Press RES button on the front panel with pointed object (such as ball-point pen) to
reset the unit to its initial settings.
Reset
UNPACK YOUR UNIT
When you unpack your new car radio, make sure that you have removed all the accessories
and information papers:
Main unit
User manual
Accessories
AR-3736D IB MUSE 001 REV1.indd 8
GB - 1
CONNECTION
Caution!
- Make sure to connect the color coded leads according to the diagram. Incorrect connections
may cause the unit to malfunction or damage the vehicle's electrical system.
- Make sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect the left
and right channel speaker cables each other or to the vehicle body.
- Make sure all the connections are completely correct before turning on your unit.
Do not connect the ignition wire (red) and the battery wire (yellow), it may cause a
short circuit, even result in fire.
INSTALLATION
The unit is installed to be an anti-theft one. The chassis of the unit wears a sliding metal housing.
Please do the connection of the power. Speakers and antenna are according to the requirement
of the instruction book. Then install the sliding metal housing in the car as follows:
GB - 2
2019/10/17 15:17:22