Cleaning And Maintenance - Royal RCNK-4 Manual De Instrucciones

IV. MANUAL INSTRUCTION
Before use, please make sure that the working voltage of the equipment (on the
techplate)matching the power supply and if the device is properly grounded. It is for-
bidden to store the explosive or flammable objects (gas bottles) near the device. The
device should be stored in rooms with good ventilation.
1. In order to prepare the pasta, please fill the tank to its half capacity.
2. Turn the thermostat knob to position „0". Plug in the power, green light will turn
on. Please set the desired temperature (by turning the thermostat knob clockwi-
se), the orange control light will turn on and the heating element will start wor-
king. When the desired temperature will be reached, the orange light will turn off.
The thermostat will maintain the desired temperature by turning on and off the
heating element. This is for maintaining the temperature and for energy saving.
You can start cooking.
3. In order to start cooking, please use attached baskets. Put the noodles into the
basket and then put the basket into the water. After cooking, baskets should be
hang on the hooks to drain the water from the noodles.
4. It must be remembered that after work, the thermostat must be switched into
„0" position (by turning the thermostat anticlockwise) and pull of the plug.
V. CLEANING AND MAINTENANCE
1. Turn temperature to 0 and unplug the machine from the power.
2. Allow machines water to cool down.
3. Drain water into container.
4. Wipe clean with cloth.
5. Please ensure no access water near controls.
6. FILL MACHINE WITH WATER BEFORE NEXT OPERATION
Failure to do this will burn out the element and void warranty.
IV. WARNING
1. It is forbidden to turn on the power with dry heating elements.
2. After each use, remove the plug from the socket to avoid unnecessary accidents.
3. If the device does not work, please do not open it, just return it to us for prior
consultation or consult with the electric specialist.
VII. REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case,
please contact your customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and join following information:
• Invoice number and serial number (the latest is to be found on the technical
plate on the device)
8
• If relevant, a picture of the damaged, broken or defective part
• It will be easier for your customer service clerk to determinate the source of
the problem if you make a detailed and precise description of the matter. A void
formulations like "the device doesn´t heat", which may mean that it doesn´t heat
enough or even not at all. Though, those two possibilities have a different causati-
on!
• Still indicate the performance of the lights to facilitate the diagnosis: Does the
green light get on when you turn on the device? Does the orange light turn on
when you set the temperature?
The more detailed your information, the quicker the customer service will be able to
answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer ser-
vice. This can lead to a loss of warranty!
9