Miscellaneous - Medisana APS Instrucciones De Manejo

Cleaning and maintaining the electrostatic dust collector
• Use a mild detergent.
• For cleaning the dust collector
• Use warm water below 40 °C.
Electrostatic dust collector
(on the back)
• If the dirt is very difficult to remove , soften the collector
detergent and use a toothbrush to clean it.
• Pay special attention not to damage any wires when cleaning the electrostat-
ic dust collector. If an electric discharge wire is torn, the dust collector
function cannot be used, or only partially used.
• Faulty wires must always be removed from the device. Otherwise this could
result in a short circuit or flying sparks. It could also damage the circuit.
• Contact your dealer or the service centre if you require new electrical dis-
charge wires.
• Do not use acidic or alkaloid detergents for cleaning. This leads to rust form-
ing on the surface of the dust collector.
• After cleaning, all parts of the device must be completely dry before they are
used again. Otherwise this could result in an electric shock or malfunction.
• If the electrostatic dust collector
supplied with power.
Fitting/removing the wire

4 Miscellaneous

, use a sponge scourer or a toothbrush.
Electrical discharge wire
(on the front)
is not fitted properly, it cannot be not be
GB
with diluted
13