EHEIM PRESS 10000 Manual De Instrucciones página 15

English
3. Open the snap locks (6 piece) of the clamping ring (⌦F).
4. Remove the filter cover ① from the filter housing ③ (⌦G). PRESS 10000 has an additional exten-
sion ②.
5. Remove the filter from the housing.
PRESS7000 (⌦H)
① Blue filter foam, coarse
② Active carbon fleece (2 piece)
③ Filter basket with EHEIM FILTERMEC granulate
④ Blue filter foam, fine
PRESS10000 (⌦l)
① Blue filter foam, coarse
② Active carbon fleece (2 piece)
③ Filter basket with EHEIM FILTERMEC granulate (2 piece)
④ Blue filter foam, fine (2 piece)
6. Clean the filter and the granulate under cold, running water.
7. Clean the inside of the filter housing with a water jet.
8. Install the filter again in reverse order.
9. Reinsert the filter cover in the filter housing
10. Pull the clamping ring upwards and lock the snap locks (⌦F).
When assembling, make sure that the bolt in the clamping ring handle catches in the opening of the
filter housing handle.
Recommended maintenance
▶ The service life of the active carbon fleece is limited to approx. 4 weeks. After this, the fleece releas-
es the harmful substances back into the water. The fleece can simply be removed or replaced by a
new fleece if necessary.
8. Clearing faults
Attention! Electrocution!
▶ Before clearing faults, remove the mains plug.
Faults
Filter capacity decreases
For other faults, please contact EHEIM Service.
Possible cause
Filter installation not correct
Filter is soiled
Pump is soiled
15
Remedy
Check whether the filter is installed
in the correct order.
Clean the filter
Clean the filter housing of the pump
(see pump operating manual)