Briggs & Stratton P3000 Manual Del Operador página 13

Parallel Operation Port
Two Briggs & Stratton inverter generators can be run
in parallel with a Briggs & Stratton parallel operation
kit (optional equipment). When running in parallel, the
total output of power is shown in chart.
Models
P2200 & P2200
P2200 & P3000
P3000 & P3000
STATSTATION™
The control panel has a built in LCD display (A) to
monitor the following features:
D
F
E
• Load Monitor (Total Generator Load)
• Hour Meter (Total Generator Hours)
• Maintenance Reminder (Engine Maintenance)
Load Monitor
The load monitor measures the output wattage
(generator load) of all the generator receptacles and
will display the percentage of total generator load.
Hour Meter
The LCD on the control panel also has a built in hour
meter that displays and records how many hours your
generator has run (up to 999.9).
Maximum Output
3000 Watts
3000 Watts
4800 Watts
C
A
B
Maintenance Reminder
The LCD on the control panel also has a built in
maintenance reminder to alert you to change air filter,
change oil, and change spark plug. The LCD display
will flash every 50 hours for the different maintenance
intervals. See Maintenance Schedule for different
maintenance intervals.
Pressing the "View" button (B) will toggle between the
flashing load percentage and the flashing hour display.
Once maintenance has been performed, you must
push and hold the "View" button on the control panel
for a minimum of 3 seconds to stop the display from
flashing and return it to normal operation.
Output Indicator
The green LED output indicator light (C) comes
on when the generator is operating normally. It
indicates that the generator is producing power at the
receptacles.
Overload Alarm
The red LED overload alarm light (D) comes on and
cuts power to the receptacles if you overload the
generator. The green output indicator light will also go
off. If the generator was overloaded, you must turn off
and unplug all electrical loads, press the "Reset" button
(E) on the generator control panel and then plug in
and restart electrical loads one at a time to continue in
normal operating mode.
Low Oil Indicator
The low oil indicator system is designed to prevent
engine damage caused by not enough engine oil. If the
engine oil level drops below a preset level, the yellow
LED low oil indicator light (F) comes on and an oil level
switch will stop the engine. If the engine stops or the
yellow LED low oil indicator light comes on when you
pull the recoil handle, check the engine oil level.
13