Power Supply - Premier SE-4926IC Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTION FOR USE
●With this hair dryer you have chosen a high quality, technically perfect and easy-to-use product.
● Careful use and maintenance ensure a long life of your new hairdryer.

POWER SUPPLY

● Prior to connecting the appliance to the mains socket, make sure that voltage and type of current
correspond with the indications on the nameplate. The appliance is designed exclusively for private use, not
for commercial use.
SATETY INSTRUCTIONS
● Read the operating instruction carefully before putting the appliance into operation.
● Always unplug your appliance after use and before cleaning it(pull on the plug, not the cable).
● There are no internal parts of the device to be maintained by the user. Therefore, never remove any
parts of the appliance, except the grate which can be removed for cleaning. Never drive any metal
objects ( such as knifes, knitting needles etc.) into the appliance to avoid any damage or electric shock.
Do not use the appliance with wet hands and by no means in the bath tub, shower, pool or over a water-
filled washbasin.
● For safety reasons, keep the appliance away from and never put it into water. If the appliance should fall
into water, unplug it immediately. Then take it out. Do not use the appliance afterwards, unless it had
been checked by an authorized customer service. The same applies to any other damages.
● Do not cover the grate at the suction intake during use. Should the air intake be blocked, the built-in
thermal safety cut-off will automatically switch off the appliance. After cooling down for a few minutes
and removal of the blockage – always unplug the appliance first – the hair dryer can be switched on
again.
● Clean the grate at the suction intake from time to time. Remove the grate and the filter turning it in a
clockwise direction. When putting the grate into place again, make sure the bayonet joint clicks into
place. The air outlet grate becomes hot during hot during operation. Therefore keep it away from the
mains cable.
● Do not bend the mains cable or wind it around the appliance to avoid any damage. Keep it away from
sharp edges or sources of heat. Always have a faulty cable be replaced only by an authorized cable of
the same type. Do not try to repair the appliance or mains cable on your own. Always contact the
customer service.
● When you put the hair dryer aside during operation it is better switched off.
● Do not use the appliance with an extension cord or on wet or humid ground.
● An electric device is not a toy. Therefore, always make sure the children do not have access to the
appliance.
● Carefully keep the instructions. When transferring the appliance, transfer the instructions, as well.
P-2

Publicidad

Tabla de contenido
loading

Tabla de contenido