Nordcap 700l Manual De Instrucciones página 9

Operation
Temperature Setting and Control

The front panel of the thermostat display:
1. Thermostat Display
2. Light Key (Active on Glass Door)
3. Defrost Key
4. Stand-By Key
5. Up Key
6. Set Key
7. Down Key
How to switch the unit from Stand By Mode to ON mode/ How to switch the unit from ON Mode to Stand By mode
• Press and hold the On-/Off
How to see the set point
• Push and immediately release the
• Push and immediately release the
How to change the set point
• Push the key for more than 2 seconds to change the set point value
• The value of the set point will be displayed and the "°C" starts blinking
• To change the set value push the "
• To memorise the new set point push the
Automatic defrost
• The appliance will automatically run defrost cycles.
Note: The defrost timer starts from the time the appliance is initially powered up.
Manual Defrost:
• Press and hold the " " DEFROST button for 3 seconds.
• The defrost cycle will start immediately and the Defrost LED illuminates.
Note: Starting a manual defrost also resets the automatic defrost timer.
How to see recorded MINIMUM and MAXIMUM temperatures
• Press and release the "
• To reset the record press
• The display will show "rSt" to confirm the RESET.
How to Lock and Unlock the keyboard
• Press both " " and "
the keyboard is locked/ unlocked.
P2M029STD - Ver.1.2
LED
key for 2s.
key, the set point is displayed.
key or wait about 15s to return to normal visualisation.
" (up) or " " (down) arrows within 15s.
key again or wait for 15s.
" or " " key. The recorded MIN ("Lo")/MAX ("Hi") temperature is displayed.
for 3s while the MIN or MAX temperature is displayed.
" key at the same time for more than 3s. The display shows "PoF"/ "Pon" to indicate that
Mode Function/ Explanation
ON Compressor Operation Indicator
Flashing Compressor Start Delay Indicator
ON Defrost enabled
Flashing Drip time in progress
ON Fan Operation Indicator
Flashing Fan Delay Indicator (After Defrost)
ON Alarm Indicator
ON Light Indicator (active on glass door)
ON Measurement Unit Indicator
Flashing Programming Mode
8
GB