nedis MPWL621BK Manual De Uso página 5

Channel selection microphone
Operation
1. Put the antennas straight up for optimal reception.
2. Connect the connection cable with the 6.35 mm plugs to the output of the receiver and
input of the mixer or amplifier. Or connect the receiver with the XLR cable (not included)
per channel (A/B) to a mixer or amplifier.
3. Connect the DC plug of the AC/DC adapter to the DC input on the rear side of the
receiver. Connect the power plug to a wall outlet and switch on the receiver.
4. Open the battery compartment of the microphone and place 2x AA batteries according
to the polarity markers and select a channel.
5. After closing the battery compartment, switch on the microphone using the ON/OFF
switch.
6. The system is ready to use.
Specifications
Frequency band:
Pre-programmed frequency:
Transmit power:
Dynamic range:
Total harmonic distortion:
Frequency response:
Modulation:
Audio output level:
Power supply:
Power consumption:
S/N ratio:
Battery:
Battery life:
UHF 840–868 MHz
UHF 863–865 MHz
10 mW
>90 dB
<0.5%
40 Hz–15 KHz, ±3 dB
FM
0–400 mV
230–240 V AC, 17 V DC
4 W
>90 dB
4x AA 1.5 V
4–6 hours
5
ENGLISH