Operation Procedures - Wagan Tech Mini Stepper Master 2273 Manual De Usuario

OPERATION PROCEDURES

Auto On/Off:
• The system turns on when any key is pressed or when it senses an input from the speed
sensor (i.e. when you begin exercising on it).
• The monitor will automatically shut off if there has been inactivity for 4 to 5 minutes.
Mode (red button):
• This key allows you to select and lock on to a particular function you desire.
• Press the button until the arrow poitns at your desired function.
• Hold this key for 3–4 seconds to have all function values reset (this is a total reset).
METER FUNCTION
Time:
1. Press the MODE key until the pointer advances to TIME.
2. When the speed sensor receives a signal input, it starts to count.
3. Total workout time begins recording when exercise has begun.
Calories:
1. Press the MODE key until the pointer changes to CALORIE.
2. When the speed sensor receives a signal input, it starts to count.
3. Total calories expended begins recording when exercise has begun.
Reps/Min:
1. Press the MODE key until the pointer advances to REPS/MIN.
2. When the speed sensor receives a signal input, it starts to count.
3. Estimated repetitions per minute begins recording when exercise has begun.
Scan:
Automatic display of the following functions in the order shown:
TIME  CALORIES  SPEED (REPETITIONS/MIN)
Count:
Displays steps accumulated since start of exercise.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2014 Wagan Corporation. All Rights Reserved.
6