Hema CME-110279.2 Manual De Instrucciones página 21

AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it is 5:10 pm, you hope
that the coffee maker will automatically start at 8:15 in the evening, first follow steps 1 to 5 of above section,
and then you can set the automatic start function as follows:
1. Press PROG button one time, the word "CLOCK" is showed at the up-right corner of
display.
2. Press the HOUR and MIN button continuously to set the current time (real clock), that is
17:10 (see Fig. 1).
Note: the time cycle is 24 hours.
3. Press PROG button again and the word TIMER shows on up-left corner of display.
4. Set the delayed starting time by pressing HOUR and MIN button repetitively, that is 20:15
(see Fig. 2).
5. Press the ON/OFF button twice, the indicator of AUTO will illuminate. The LCD will display the current clock.
You may see the automatic start time by pressing PROG twice.
Note:

You may cancel the automatic start function by pressing ON/OFF button once to stop machine, or pressing
ON/OFF button twice to start brewing immediately.

You can reset the present time and automatic start time by pressing the PROG button once or twice.
Remember when there is a "CLOCK" displayed, you can modify the current time, and when "TIMER" is
displayed, you can modify the automatic start time. If there is no word marking on top, the display shows
the set current time. The coffee maker will adjust to the new time setting if you changed the time midway.

When the time is due the indicator of AUTO will go out, while the indicator of RUN turn on and the unit
starts brewing. When brewing is finished, the coffee maker will be automatically shut off after 40 minutes
if it is not manually switched off.
MEMORY FUNCTION
If the power supply has been broken off during operation, the appliance will be continued previous operation
automatically from the point when the disconnection occurred provided that the pause does not exceed 10
seconds, even without pressing any button. In the event the pause time exceeds 10 seconds, the display shows
the default setting, and the appliance must be re-started.
DESCALING

Regularly descale the coffee maker. The intervals of descaling depend on the water hardness and frequency
of operation. In case of average water hardness we suggest descaling every 3 or 4 months. Please use a
commercially available decalcification agent.

Fill 400 ml of water into the reservoir and add the necessary amount of decalcification agent in accordance
with the dosing instructions.

Let the decalcification agent sink in the coffee maker for about one hour. Switch on the unit after one hour
and let the water pass through. After that you should brew water twice and rinse all detachable
components, in order to clean off any residue.
CLEANING AND MAINTENANCE

Before cleaning remove the mains plug and let the device cool down.

Never immerse the device in water. Please use a slightly damp cloth to clean the surfaces.

Avoid using acrid or scrubbing cleaning agents.

Keep the coffee maker in a dry place out of reach from children when cooled off and cleaned.

Do not wrap the cord around the device.
- 20 -