Ecom Instruments DCX 00 Instrucciones De Uso página 16

An adapter plug is not required for use in North America.
Here the two-pin plug type A (North America) must be unfolded from the mains
adapter. You can now insert a phone into the charging element for the phone (2)
as described under point 4 „Safety regulations", and/or you can insert a battery
module into the charging element for the battery module () as described under
point 4 „Safety regulations".
6.4 LED for battery module status
red Battery module is being charged
green Battery module is fully charged
red flashing Fault! Disconnect the desktop charger from the socket, remove the battery module
and re-insert it. If the LED continues to flash after re-connection to the power
supply, it means the battery module is defective. Do not continue using this battery
module!
6.4 LED for desktop charger status
blue The desktop charger is connected to the power supply.
blue Fault! Disconnect the desktop charger from the socket and remove the battery
flashing module and/or the phone. Then re-insert the device(s) you removed. If the LED
continues to flash after re-connection to the power supply, it means the battery
module is defective. Do not continue using this battery module!
Please refer to the phone's display for information regarding the charge status of the battery located
in the phone.
4