Replacing The Battery - Snuza Go! Manual De Instrucciones

9.3 Replacing the Battery

For all SE models: use a CR2 (CR15270) battery available from most
retail outlets.
For all other models: use only a 14250 battery that delivers 3V 600mAh,
available from a specialist battery supplier or your national Snuza distributor.
Please see our website www.snuza.com for information about batteries and
details of your national distributor.
** The serial number is located inside the battery housing (it can also be found on the original
Snuza packaging). To locate the serial number, remove the battery
cover and battery as per the instructions below
1. Use your fingernail or a small flat implement. With a
pinching action (Figure 1), gently pull back the Battery
Cover Release Clip (9) on the underside of the monitor
and lift the Battery Cover at the same time (Figure 2).
5. Test the unit by switching on and ensuring that the Battery Indicator Light
(2) flashes green.
6. If the unit starts emitting a beep after the battery has been replaced, simply
press the ON/OFF (5) and MODE/OFF (6) buttons simultaneously to turn it off.
Go manual-USA_10.14.indd 12
:
2. The Clip Guard Rail (10) prevents
the clip from bending too far. Do not
try to bend the clip beyond this point.
3. Remove the depleted battery.
The serial number is located
beneath the battery.
4. Insert the new battery, negative end first, as shown in
Figure 3. Ensure that the polarity is correct (align the
positive end '+' of the battery with the '+' symbol in the
battery housing). Replace the Battery Cover and ensure
that it is correctly closed (Figure 4).
12
2014/11/11 12:36 PM