Question:
I have a regular 10 amp battery charger, can I use it to recharge the
Booster PAC?
Answer:
No, only the supplied wall charger should be used.
Question:
Is the Booster PAC goof proof?
Answer:
No, jump starting instructions must be followed. Read and understand all
safety and operating instructions in this manual and those found in the
owner's manual of any vehicle being jump started before using your
Booster PAC.
Question:
I'm recharging my Booster PAC. Should the green CHARGE COMPLETE
light immediately come on?
Answer:
No. First the yellow CHARGING light will come on to indicate the
charging process is beginning. Then, the red POWER LEVEL lights come
on in sequence as the level of charge increases. Finally, the green
CHARGE COMPLETE light will come on, but only when the Booster PAC
approaches full charge.
Question:
How long should I charge the Booster PAC?
Answer:
It should be charged for a minimum of 30 hours when new. Your Booster
PAC can be left on the wall charger continuously. When recharging with
the wall charger, the Booster PAC should be charged for 4 to 6 hours per
light that remains unlit when the TEST button is pressed.
Question:
How do I know when the Booster PAC is fully charged?
Answer:
Follow all charging instructions. Remove the Booster PAC from the wall
charger and press the TEST button. If all power indicator lights come on,
it is fully charged.
Question:
How can I test the battery in my Booster PAC to see if it needs to be
replaced?
Answer:
We recommend that you use a 100 amp battery load tester. Load the
Booster PAC battery for 6 seconds with a 100 amp load and it should
maintain at least 9 Vdc.