Troubleshooting - Troy-Bilt Polar Blast 3310 Manual De Instrucciones

Troubleshooting

Problem
Excessive vibration
Loss of power
Unit fails to propel itself
Unit fails to discharge snow
Cause
1. Loose parts or damaged auger.
1. Spark plug wire loose.
2. Gas cap vent hole plugged.
1. Drive control cable in need of adjustment.
2. Drive belt loose or damaged.
1. Chute assembly clogged.
2. Foreign object lodged in auger.
3. Auger control cable in need of adjustment.
4. Auger belt loose or damaged.
5. Shear pin(s) sheared.
Remedy
1. Stop engine immediately and disconnect
spark plug wire. Tighten all bolts and nuts. If
vibration continues, have unit serviced by an
authorized service center.
1. Connect spark plug wire.
2. Remove ice and snow from gas cap. Be
certain vent hole is clear.
1. Adjust drive control cable. Refer to
Maintenance & Adjustments section.
2. Replace drive belt. Refer to Service section
1. Stop engine immediately and disconnect
spark plug wire. Clean chute assembly and
inside of auger housing with clean-out tool
or a stick.
2. Stop engine immediately and disconnect
spark plug wire. Remove object from auger
with clean-out tool or a stick.
3. Adjust auger control cable. Refer to Assembly
& Set-Up section.
4. Replace auger belt refer to Service section.
5. Replace shear pin(s).
8
23