Sears Craftsman 358.794750 Manual De Uso página 9

SHOULDER STRAP ATTACHMENT
(optional accessory #71-85936)
1. Pass the shoulder strap over your
head and onto your left shoulder.
2. Snap the hooks onto the retainers
(see following illustration).
BLOWER USE I VACUUM USE
RetainerI Retainer
Retainer / I Retainer
_,_. _ i_:,_i --
KNOW YOUR BLOWER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments. Save this manual for future reference.
Upper Vacuum Tube Elbow Tube
Lower Vacuum Tube (/X_
STOP
Throttle Switch
Trigger . Spark
Starter //_--_I _, Plug Upper Bl°wer Tube
Rope ........
_.-__"'\_ " Start Leve,
Primer /__
Bulb __.f_ Vacuum Handle
Lower Blower Tube
STOP SWITCH
The STOP switch is used to stop the
engine. To stop the engine, push and
hold the STOP switch in the STOP posi-
tion until the engine stops.
THROTTLE TRIGGER
The THROTTLE TRIGGER is used to se-
lect the desired engine speed.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate primer bulb by
pressing it and allowing it to return to
its original position.
START LEVER
The START LEVER helps to supply fuel to
the engine to aid in starting. Activate the
starting system by moving the start lever
to the START position. DO NOT squeeze
the throttle trigger until the engine has
started and runs. After the engine starts,
allow the engine to warm-up 10-15
seconds, then fully squeeze the throttle
trigger to deactivate the starting system
(start lever returns to RUN position).
-9-