Homelite UT46510 Manual Del Operador página 13

Cultivadora eléctrica
Ocultar thumbs Ver también para UT46510:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING THE FRONT HANDLE
See Figure 4, page iii.
 Position the front handle as shown.
 Depress the buttons on the handle and insert into the
frame. Press down on the handle until the button on the
handle clicks into place.
ASSEMBLING THE WHEEL/DRAG STAKE
ASSEMBLy
See Figure 5, page iii.
 Locate the axles, hitch pins, washers and wheels.
 Slide the wheel onto the axle.
 Place a washer on the outside of the wheel and slide to
rest against the wheel.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel/drag stake assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE WHEEL /DRAG STAKE
ASSEMBLy
See Figure 6, page iii.
Use the wheel/drag stake assembly to transport the unit to
and from the work area or when cultivating.
To install:
 Remove the adjustment knob located at the back of the
tine shield.
 Insert the wheel/drag stake assembly into the bracket at
the back of the tine shield. To place the wheels in a high
position, insert the knob in the first hole. For a lower wheel
position, insert the knob in the second or third hole.
 Insert adjustment knob through holes in bracket, pass-
ing through desired hole in wheel/drag stake assembly,
to secure wheel/drag stake assembly at desired height.
 Thread the adjustment knob into the nut and tighten, to
secure wheel/drag stake assembly.
ASSEMBLy
INSTALLING THE TINES
See Figure 7, page iv.
The cultivator has four tines —two inner tines stamped B
and C, and two outer tines stamped A and D. For correct
operation of the unit, the tines must be installed in the cor-
rect orientation.
NOTE: The view of the gearbox for tine installation is from
the front of the cultivator.
 Lean the unit back on its wheels so that the handlebar
rests on the ground.
 Place tine C on the tine shaft to the left of the gear box.
The stamped side of the tine should face away from the
gear box.
 Place tine B on the tine shaft to the right of the gear box.
The stamped side of the tine should face away from the
gear box.
 Place a felt washer on each side of the tine shaft, and
slide to rest against the inner tines.
 Place the outer tine stamped D on the left side of the tine
shaft. The stamped side should face in toward tine C.
 Place the outer tine stamped A on the right side of the
tine shaft. The stamped side should face in toward
tine B.
NOTE: When installed correctly, the angled edge of the
tine blades should face the ground.
 To secure the tines to the tine shaft, insert the hitch pin
into the holes located on either side of the tine shaft.
NOTE: The unit will not operate properly if the tines are in-
stalled incorrectly. If you notice a problem with the cultivating
operation of the unit, check for proper tine positioning.
Page 9 — English

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido