Boso Bosch+Sohn Medisol comfort Instrucciones De Uso página 30

4. Make sure that the medicine conduction cone is properly fit-
ted on the air conduction cone inside the nebulizer (Pic. C).
5. Put the prescribed quantity of medicine into the nebulizer
(Pic. D).
6. Close the nebulizer by turning clockwise the two parts,
paying attention that they are thoroughly sealed (Pic. E).
7. Connect one end of the air tube to the nebulizer (Pic. F) and
the other end to the air outlet (Pic. G) on the device.
8. Connect the required accessory part (mouthpiece, adult
mask, child mask or nosepiece) to the nebulizer. If you need
to use the mask, insert it directly onto the nebulizer (Pic. H).
!
Note
The most effective form of nebulisation is by using the mouth-
piece. Nebulisation using a mask is only recommended if it is
not possible to use a mouthpiece (e.g. for children who are not
yet able to inhale using a mouthpiece). When using a mask to
inhale, take care to ensure the mask fits well and the eyes are
unobstructed.
9. Plug the device into the wall socket, make sure that the main
supply corresponds to the electrical rating of the device.
10. To start the treatment, set the "I/O" switch into the "I" posi-
tion.
!
ATTENTION: this device is for intermittent use: 30
min ON / 30 min OFF.
11. Inhale the aerosol solution using the prescribed accessory.
12. When the treatment has been completed, switch the unit off
by setting the "I/O" into the "O" position and disconnect the
plug from the wall socket.
30