Clarke American Sanders 07104A Manual Del Operador página 12

ENGLISH
EN
How to Operate the Machine
6. When contact wheel is fully engaged with the
surface, gradually adjust your pace for adequate
finish removal. Keep sander in motion while the
contact wheel is engaged with the surface or
dwell marks will occur.
7. Move the machine in the direction of the grain in
the wood whenever it is possible. Sand the
surface at a constant pace.
8. Gradually feather-cut out at the termination point
by easing the contact wheel up with the control
lever. (See Figure 13)
9. Repeat technique described in steps 5, 6, 7, and
8 and sand back down pass just made. When
completed, begin a new pass by overlapping
previous pass half the width of the abrasive.
Stagger termination points to prevent a distinct
ridge and a better blend when edging.
10.Empty contents of the dust bag into a metal
container located outside the building. Dust bag
should be emptied whenever full, as indicated on
bag.
WARNING: Do not overfill dust bag or seri-
ous fire may result. Never leave
a dust bag containing dust unat-
tended. Sanding dust can self
ignite and cause a fire or explo-
sion. Use only genuine Clarke
American Sanders replacement
bags.
CAUTION: An overfilled dust bag may ef-
fect machine balance and per-
formance.
disturb dust bag and elbow while
sanding or damage to the floor
may occur.
-12-
Do not handle or
Clarke
Figure 13
® American Sanders Operator's Manual (EN) - Floorcrafter