Dino-Lite DermaScope Manual De Usuario página 13

Measurement tools – Many different measurement types can be
done with the measurement tools. The double flash icon gives you
access to the grid and ruler settings. To make a measurement on
your picture, choose one of the measurement icons. Then read the
magnification factor from the focus ring and input this value into
the box to the right of the icon bar. For increased accuracy, perform
a calibration with the aid of the calibration sheet that is supplied
with your Dino-Lite.
Note: The values reached with the DinoCapture software
are not intended to be used for diagnostic purposes.
Line
Continuous
line
Point to line
Polygon
Left click and drag to the desired length, and click
again to finish.
Click and drag to form one section of distance, click
again to start another section. Continue until the
total desired distance is measured. Double click to
finish.
Create a line to represent the base by clicking
once to start, drag, and then click again to set the
endpoint. Branch off from the base line to start
measuring the line that is 90 degrees from the base
line and a final click to finish the measurement.
Click and drag to form the desired length, and click
again to start the next section. When finished,
double click to finish the polygon measurement.
Dino-Lite Medical User Manual
English 11