Multiplex HFMx M-LINK Manual De Instrucciones página 11

6.3.: Connecting the HFMx M-LINK 2.4 GHz RF module to
the transmitter's Trainer socket
1. Insert the DIN plug in the transmitter's Trainer socket. The
correct orientation is dictated by the lug in the connector:
2. If the cable exits the connector in an awkward position, the
internal part of the DIN plug (contacts and contact holder)
can be rotated as follows:
•
Undo the screw in the DIN plug (plain or Torx screw-
driver) and lift off the top of the connector housing.
•
Raise the internal part (contacts and contact holder)
slightly, and rotate the assembly to the correct position.
Take care not to damage any wires or soldered joints!
•
Replace the top housing of the DIN plug and tighten the
retaining screw. Insert the DIN plug in the socket:
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions
HFMx M-LINK 2.4 GHz RF Module
6.4.: Installing the 2.4 GHz aerial
Screw the 2.4 GHz aerial into the socket on the module:
•
•
•
!
rectly aligned when screwing them together.
7.
To operate using the M-LINK 2.4 GHz system the transmitter
must always be set to PPM mode (not PCM!).
This applies not only to normal operations (
binding mode (
8.
The transmitter with M-LINK technology (in this case with the
HFMx M-LINK 2.4 GHz RF module) and the receiver will not
work until they have been "taught" to recognise each other. This
process is known as "binding".
!
You will find general information on the subject of binding, and
on fault-finding and correction relating to the binding procedure,
in the operating instructions supplied with your MULTIPLEX
M-LINK receiver.
The binding procedure in detail:
1. Switch the transmitter OFF.
2. Place the transmitter and receiver very close to each other.
3. Switch the M-LINK transmitter ON in binding mode. This is
4. Switch the M-LINK receiver ON in binding mode
5. When the transmitter and receiver have identified each other
Grip the aerial by the knurled section.
The screwed joint must be firmly tightened, so that the aerial
cannot possibly come loose in use – e.g. when it is rotated in
the installed position.
Check the screwed aerial joint at regular intervals!
Note: avoid using excessive force, and keep the parts cor-
2.4 GH O
Z PERATION
A S PPM M
LWAYS ELECT
8.) and range-check mode (
B P
INDING ROCEDURE
Note:
accomplished as follows:
•
Move the slide switch on the flat face of the HFMx
M-LINK 2.4 GHz RF module to the "2.4 GHz" position
( 9.).
•
Press the SET button on the HFMx M-LINK 2.4 GHz
RF module and hold it pressed in.
•
Switch the transmitter ON.
•
Release the SET button as soon as the LED on the
HFMx M-LINK 2.4 GHz RF module starts flashing
at a rapid rate.
(switch ON with the SET button pressed in; see the
instructions provided with the M-LINK receiver):
=> The binding process now takes place.
(this takes a few seconds), both automatically switch to
regular transmit / receive mode
(The system in use 9.):
=> The LED on the 2.4 GHz RF module flashes slowly and
regularly at intervals of approximately two seconds.
:
( PCM)
ODE NOT
9.), but also to
11.).
Page 3/6