Cleaning And Care - Carrera 524 Manual De Instrucciones

Trimmer attachment
The trimmer attachment is designed for trimming nose/ear hair and
eyebrows.
1. Make sure that the attachment has been properly placed.
2. Push the on/off switch up to switch the appliance on.
3. Use the cutting unit to trim the visible hair in the front area of your
nostrils and ears.
4. To trim your eyebrows, place the trimmer close to the skin; then
slowly and carefully move across the excessive hair. In order to
prevent unpleasant results, do not remove too much hair at once.
WARNING! Risk of injury
Do not insert the cutting unit too far into your nostril and/or
ear cup.
5. Push the on/off switch down to switch the appliance off; then clean
the appliance and attachment.
Attachment comb (4 mm / 8 mm)
The attachment comb is designed for trimming the eyebrows.
1. Attach the attachment comb to the cutting unit (see fig. B).
2. Make sure that the attachment has been properly placed. There
is an oval opening on the back of the attachment comb that must
lock into place above the small tooth on the trimmer attachment.
3. Push the on/off switch up to switch the appliance on.
4. Put the attachment comb to the eyebrows and switch the appli-
ance on. Trim your eyebrows against the direction of growth.
5. Push the on/off switch down to switch the appliance off; then clean
the appliance and attachment.
24 GB

05. CLEANING AND CARE

CAUTION! Material Damages
Always switch the appliance off before cleaning it.
When cleaning the appliance, ensure that the lid of the battery
● ●
compartment / bottom of the appliance is tightly closed.
Never immerse the appliance in water or any other liquid.
● ●
Do not use aggressive or abrasive cleaning agents.
● ●
NOTE:
Clean the attachment after each use.
● ●
1. Switch the appliance off.
2. Remove the attachment from the appliance.
Appliance
1. Use a soft and slightly damp cloth to clean the housing.
2. Use a cleaning brush or dry cloth to clean the upper end of the
appliance.
Trimmer attachment
Remove the trimmer attachment.
● ●
Rinse it with water and allow it to dry completely before using it
again.
Attachment comb
Clean the attachment comb with the cleaning brush or rinse it with
● ●
water. Allow the attachment comb to dry completely before using
it again.
GB 25