Installation Overview (Matrx® Pb Backs) - Invacare Matrx Manual De Servicio

Invacare® Matrx® accessory
3. Adjust the height, width and angle of the extension bracket A on
the mounting plate B.
C
1
A
F
Working on one side of the back shell C, align the mounting
4.
holes in the mounting plate B with the pin hole locations on the
elite back shell (1).
5. Install/secure the mounting plate using the mounting pins E and
flange nuts F provided with the back shell (2).
Refer to your Matrx® Elite user manual for instructions on
setting the proper mounting pin depth.
IMPORTANT!
– Once the pin depth has been properly adjusted, ensure
the flange nuts are fully tightened against the mounting
plate.
3.2 Installation Overview (Matrx® PB Backs)
G
2
4
2
E
E
I
A
F
J
E
C
D
6. Repeat steps 3 and 4 for the opposite side of the back shell.
D
A
Install the support clips D (included separately with your support
7.
harness) onto the extension bracket A using the 12 mm button
head screws G provided.
8. Make any final adjustments to the extension bracket position
(height/width/angle) and fully tighten hardware.
9. Verify that all remaining mounting/installation hardware is secured.
With the Support Harness Mounting Bracket Assembly fully
installed, please refer to your Support Harness User Manual
(provided separately) for important safety information and
instructions regarding the proper set-up and installation of
your support harness.
H
B
1
D
G
A
Pos. Qty.
A
1
B 1
C
1
D 1
E
4
F 2
G
2
H 2
I –
–
J
1 With headrest clamp
2 Without headrest clamp
Description
Support Harness
Mounting Bracket
Shim
Multi wrench,
universal
Multi-metric Hex key,
4mm/5mm
M6 Nyloc nut, BZ
M6 1.0 x 12 mm
Button socket cap,
alloy steel, BZ
M6 1.0 x 20 mm
Button socket cap,
alloy steel, BZ
M6 1.0 x 25 mm
Button socket cap,
alloy steel, BZ
Support harness clips
(not included)
Headrest clamps (not
included)
1589332-A