Power Supply Connection; Operating The Pressure Washer; Water Flow And Pressure Adjustment - Snap-On 870552 Manual De Instrucciones

POWER SUPPLY CONNECTION

KEEP all electrical connections dry and off the ground.
NEVER touch the plug with wet hands.
NEVER cut or remove grounding blade (round longer pin) on GFCI
attachment plug.
1. Connect the Pressure Washer GFCI power cord to a
dedicated electrical outlet.
2. Press the RESET button on the GFCI to ensure its
proper operation.
Outlet capacity must be 120V, 60HZ and minimum 15 AMP.

OPERATING THE PRESSURE WASHER

ALWAYS wear approved safety glasses when operating Pressure
Washers. Spray can splash back or propel objects, including
incorrectly attached accessories.
The high pressure stream of water that this equipment produces can cut
through skin and its underlying tissues, leading to possible amputation.
Spray gun traps high water pressure, even when the motor is stopped and water
is disconnected, which can cause injury.
Kickback from spray gun can cause you to fall.
1. For your protection, wear the protective safety glasses (Not provided).
2. Place the Pressure Washer near the working surface.
Make sure that the water source is turned on and all connections
to the Pressure Washer and Spray Gun are secure and without any water leakage.
The Pressure Washer motor runs ONLY when the trigger is engaged.
Press Reset
13
3. Hold the gun securely with both hands. Point the gun in a
safe direction. Make sure that the gun safety is unlocked and
squeeze the trigger to allow any air that is trapped inside the
unit and hoses to escape. Continue to squeeze the trigger
until a steady stream of water comes from the nozzle.
4. Turn on the ON/Off switch on the back of the Pressure
Washer. NOTE: Motor does not start until trigger is pulled.
5. Point the gun in a safe direction and squeeze the trigger
to start motor and water flow.
Make sure wand is
SECURELY tightened to Gun. If the wand
is not securely locked into place, it could
be ejected under high pressure when
operating the gun, possibly causing
injury or damage.

WATER FLOW AND PRESSURE ADJUSTMENT

The angle of spray and water pressure coming out of the nozzle may be adjusted
by rotating the front of the nozzle. This will vary the spray pattern from approxi-
mately a 0° narrow high impact stream (by turning the nozzle fully to the left) to a
60° wide fan spray (by turning the nozzle fully to the right).
A narrow stream has high impact force on the cleaning surface and results in max-
imum deep cleaning in a concentrated area. However, this narrow high impact spray
must be used cautiously, as it may damage some surfaces.
A wide fan pattern will distribute the impact of the water over a larger area, result-
ing in excellent cleaning action with a reduced risk of surface damage. Large
surface areas can be cleaned more quickly using a wide fan pattern.
14
Squeeze
Press Button