Fcoe V-eyes Manual De Uso página 9

Binding the FCOΞ LinX System
At first you have to bind the FCOΞ LinX
transmitter and the LinX receiver. The system
just has to be bind one time before the first use.
Start with switching on the transmitter by
pushing the switch to the left or right. Connect
the receiver with the camera and switch the
camera on. Press the bind button (9) with the
help of a sharp item (pencil, toothpick...) and
the center button (3) on the transmitter at the
same time for 5 seconds.
The successful binding will be indicated by flashing of the red LED. Switch off the
camera and the transmitter and pull off the receiver.
The LinX transmitter has to be connected to the
LinX docking port of the FCOΞ V-Eyes Base.
Depending on the alignment of the camera, the
switch of the transmitter has to be pushed to
the left (upright/regular) or to the right (hanging/
inverse).
Usage of the FCOΞ V-Eyes in combination with your R/C system
Schematic View
1. V-Eyes Glasses
2. V-Eyes cable
3. V-Eyes Base
4. Transmission Set
2.4/5.8GHz receiver
V.1.02
5. PPM Trainerport-cable
6. R/C system transmitter
7. Release-button/switch
8. R/C system receiver
www.FlyCamOne.com
9. RX-cable
10. camera
11. Transmission Set
2.4/5.8GHz
transmitter