Information Codes - Samsung WF409 Serie Manual De Usuario

Ocultar thumbs Ver también para WF409 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INFORMATION
CODES
Information codes may be displayed to help you better understand what is occurring with your washer.
Redistribute the load, press the Start/Pause
button.
Unbalanced load prevented your
washer from spinning.
Door is unlocked when washer is
running.
....
Door is open when washer is
dS
running.
Your washer failed to lock the
door.
Water temperature control
problem.
(Heater control problem)
Your washer has tried to fill but
has not reached the proper water
level.
The door will not unlock.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
Your washer has tried to fill but
was unsuccessful.
The hot/cold water hose
nF1
connection is not correct.
Problem with control.
A fault is detected in the water
OE
level sensor.
Jammed key.
Temperature sensor problem.
tE
Motor problem.
Press the Power button to turn off your washer,
then restart the cycle. If the code reappears, call
for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Call for service.
Call for service.
Make sure the door is firmly closed.
Press the Power button to turn off your washer,
then turn it on again. If the code reappears, call
for service.
Before calling for service, check the following.
Clean the filter (See page 25).
or
1. Turn off the unit for 10 seconds and then turn
it on again.
2. Select the Spin Only cycle.
3. Press the Start/Pause
to drain the water.
If it still does not drain, call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
Please connect the hot/cold water hose
connection correctly.
Call for service.
Call for service
Call for service
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
troubleshooting
and information codes 29
WF409ANW-02657D-02
EN.indd
29
2009-12-04
L._.,2ti_11:19:46

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wf407 serie

Tabla de contenido