Important - Welby TEN 603 Manual Del Usuario

5. At the start of stimulation, the out-
put intensity is also set by default at
0. Select the desired output intensity
with the intensity buttons
for the corresponding channel. For
CH1 and CH2, intensity can be indi-
vidually adjusted (Fig. 6).

Important:

As soon as you set the intensity setting to 1, that channel
is active and current will flow between the adhesive
electrodes.
6. We recommend using the locking
function, so that buttons are not
unintentionally pressed during use.
To lock/unlock the keypad, hold
the button
2 seconds (Fig. 7).
7. After the stimulation time has ended, hold the
down for approx. 3 seconds to switch off the device.
Notice:
If you wish to end the stimulation treatment prematurely,
press the
idle for more than 1 minute after being switched on.
down for approx.
6
button. The device will shut off automatically if
/
8 13
Application
Fig. 6
Fig. 7
button
33