Biesemeyer T-Square BC30 Manual De Instrucciones página 9

ASSEMBLY (FOR ALL OTHER SAWS)
ASSEMBLE FRONT RAIL
1. Raise saw blade (A) Fig. 15. Place a straight edge
(B) against the right side of saw blade extending out
over the front of the saw as shown. Position front rail
(C) against the edge of saw table and lightly clamp in
place using bar clamps (D). Align notch (E) in front rail
(C) with the straight edge (B) as shown. NOTE: Any
portion of the notch needs to align with the straight
edge. Final calibration will be explained later.
2. Using template (F) Fig. 16, check and adjust the
front rail at both sides of saw table, to make sure the
horizontal portion of front rail (C) is parallel with the
table top and then tighten bar clamps. The rail should
be down from the top of the table 2-27/32".
3. When you are certain front rail (C) is level with the
table surface, drill four 1/4" through holes into the saw
table using the 1/4" counter sunk holes in the front rail
as a template. IMPORTANT: Before drilling, check
to make certain there is no interferance such as
casting ribs behind front edge of saw table.
4. Fasten front rail (C) to saw table using the four 1/4-20
x 1-1/4" long flat head screws, flat washers, lock
washers and hex nuts supplied.
ASSEMBLE REAR RAIL
5. Clamp rear rail (G) Fig. 17, to back of saw table using
bar clamps making certain notch (E) in rail is aligned
with saw blade (A) as shown, using straight edge (B).
Make sure the two cutouts in the rail are below the
bottom of the miter slots in the saw table.
6. Check to make certain there are no interferance such
as casting ribs behind the rear edge of the saw table
and drill a minimum of two through holes into the
saw table using the countersunk holes as a template.
Fasten rear rail to saw table using the 1/4-20 x 1-1/4"
long flat head screws, flat washers, lock washers and
hex nuts supplied. IMPORTANT: If there is no room
in rear edge of the table to drill through holes, it will
be necessary to drill #7 holes and tap holes with a
1/4-20 tap.
7. After fastening the rear rail to the saw table, tilt the saw
blade to make certain there is no interferance between
the saw guard and the rear rail. If there is, it will be
necessary to enlarge the cut-out (H) Fig. 17, in the rear
rail.
EXTENSION TABLE & SUPPORT LEGS
8. Assemble the 3/8" jam nut (I) onto leveling screw
(J). Thread leveling screw into foot adapter. Fig. 18
illustrates the foot leveling assembly on the table leg.
Assemble the remaining foot assembly to the other leg
in the same manner. NOTE: Height adjustments will
be made later.
A
B
C
A
B
E
G
I
9
E
C
D
FIG. 15
FIG. 16
H
FIG. 17
J
FIG. 18
F