EHEIM VAC40 Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
English
4.
Commissioning
Assembly type 5360 (⌦C)
1. Connect the metal bracket a to the container base.
2. Tighten with both screws from below (Â size 5).
Switch illustration c
= AUTOMATIC
Automatic mode for pond or pool floor cleaning
0
= OFF
Appliance is switched off.
= MANUAL
Continuous operation as wet/dry suction cleaner.
5.
Usage as pond sludge suction cleaner, type 5360 (⌦A/D)
▶ Ensure that the appliance is switched off. Switch c in position (0) = OFF.
▶ Never use the appliance without the appropriate filter.
Assembling the appliance (⌦D)
1. Open both closing brackets d on the container h and remove the motor head b.
2. Pull the blue filter foam e over the suction cage (⌦D) and put the motor head b back onto the
container h.
3. Close the appliance once again with the aid of both closing brackets d.
4. Remove the plug g on the container base.
5. Fix the outlet hose  to the container outlet and put the strainer  over the end of the outlet hose
(⌦D).
6. Put the suction hose  into the intake nozzle f on the top of the container.
7. Connect the pipe sections  (up to 4 sections) to the connection piece  according to the water
depth and put the pond suction nozzle  (used for the suction of pond sludge, plant residue etc.) on
the pipe end.
▶ Observe the max. immersion depth of 1.2 m and the max. working height of 1.5 m (⌦G).
Operation
▶ When setting up the appliance, maintain a minimum distance of 2 m to the bank or pool edge (⌦G).
▶ Ensure that there are no people in the water.
▶ Ensure that the dirty water can flow out of the outlet hose without any problems and is aimed in the
direction in which the dirty water should flow.
16

Publicidad

Tabla de contenido
loading

Productos relacionados para EHEIM VAC40

Este manual también es adecuado para:

5360

Tabla de contenido