Using The Remote Control; Operation; Troubleshooting - Delta 50-871 Manual De Instrucciones

USINg THE REMOTE CONTROL

To reduce the risk of fire or electric
shock, do not use this unit with any
solid-state speed control device.
The remote control provided with this unit is not
considered a solid-state device.
The Air Cleaner is equipped with a REMOTE CONTROL
(A) Fig.8A.
NOTE: The remote requires two (2) AAA batteries (not
supplied). The Battery housing is located underneath
the back cover.
Notice that the remote control has three control buttons
(Fig. 8A): TIME (B), ON/OFF (C), and SPEED (D). These
buttons correspond to the LED sensor panel on the
rear of the machine (K) Fig. 8B.
NOTE: When the machine is connected to the power
source, a green light (E) will be activated on the panel.
To activate the blower unit, press the "ON/OFF" button
(C) Fig. 8A. The machine will begin in the default speed
of HIGH on the sensor panel. Press the SPEED button
once, and the machine will run at the MEDIUM level.
Press the SPEED button again, and the machine will
run at the LOW level. Press the SPEED button a third
time, and the machine will return to HIGH speed mode.
To turn the machine off, press the "ON/OFF" button (C)
Fig. 8A.
This unit has a timer that can be set by remote control.
NOTE: The air cleaner may produce a slight odor for the first few hours of operation due to the protective coating
which is applied to internal components. This odor will dissipate and should be disregarded.
IMPORTANT: Never operate the air cleaner without air filters in place.
1. Make SURE that the filter material is correctly installed in place.
2. Plug in the power cord.
3. Press the ON/OFF button, START operation. (The RUN light will light up in the color of the relevant speed, and
the POWER light will stop flashing.)
4. Press the TIMER button to set the time, the MAX time setting is 15 hours.
The dELTA® 50-871 3 Speed Air Cleaner can be used in
a. bench-top sanding applications.
b. circular saw applications.
c. dry wall applications.
d. shop cleaning applications.
e. floor sanding applications.
f. any other application where non-metallic dust is a factor.
For assistance with your machine, visit our website at www.deltaMachinery.com for a list of service centers or
call the DELTA Power Equipment Corporation help line at 1-800-223-7278.
®
When the machine is ON in the speed setting desired,
pressing the "TIME" button (B) Fig. 8A on the remote
control will set the machine to run for one hour.
Pressing the "TIME" button again will set the machine
to run for two hours. Notice that the light on the sensor
panel has now moved to the 2HR location (G) Fig. 8B.
When the "TIME" button is pressed a third time, the
machine will run for three hours. At this point the red
light will show up under the 1HR and 2HR locations.
When you press the "TIME" button a fourth time, the
unit will run for four hours. Notice that the indicator
light glows at the 4HR location. Pressing the "TIME"
button further will increase the time settings in one
hour increments to a maximum of fifteen hours.
All functions can be manually controlled by using the
two buttons on the sensor panel (K) Fig. 8B.

OPERATION

TROUBLESHOOTINg

8
FIg. 8A FIg. 8B