5. Overview
Refer to the illustrations on page 2 of this manual.
A docking connector
B speaker (2x)
C power LED
D display
E source button (SOURCE)
F volume down button (VOL-)
G volume up button (VOL+)
6. Use
Refer to the illustrations on pages 2 and 3 of this manual.
•
The FM9 can receive power either via batteries (not incl.) or via the mains (adaptor included).
Note: when using batteries, the connected iPhone/iPod will not be charged.
Mains: plug the connector of the included mains adaptor into the DC input [N]. Make sure the
o
power switch [M] is in the OFF position and plug the adaptor into a suitable mains outlet.
Batteries: make sure the power switch [M] is in the OFF position and insert batteries in the
o
battery compartments [K] (refer to §7 for battery handling instructions).
•
Set the power switch [M] to the ON-position. The power LED [C] lights up.
General
•
Most functions are only available through the remote control; only a limited number are available on
the device itself.
•
Remove the plastic tab from the remote control prior to first use.
•
Press the TONE button to set the Volume, Bass and Treble. Use the volume up and down buttons (on
remote:
VOLUME
Press once to set the volume (0~40), the display indicates Volume.
o
Press twice to set the bass (-8 ~ +8, step 2); the display indicates Bass.
o
Press three times to set the Treble (-8 ~ +8, step 2); the display indicates Treble.
o
Note: the output volume can also be set directly using the volume up and down buttons (on remote:
VOLUME
Setting the time
•
Press the TIME button; the hour indication starts to flash.
•
Change the hour using the volume up and down buttons (on remote:
VOL- [F] / VOL+ [G]).
•
Press the TIME button again to confirm and move to the minutes setting.
•
Set the minutes with the volume buttons. When finished, wait ±7s for the seconds to stop flashing.
iPhone/iPod
•
Gently place your iPhone/iPod (not included) on the docking connector [A].
•
Press the power button on the remote control (
display [D] lights up blue.
•
Press the SOURCE button [E] until the display indicates iPod.
•
Press the MENU button to go to the iPod menu.
•
Use the
and
choose an item.
•
Press the play/pause button (
•
Shortly press the previous (
•
Press and hold the previous (
Notes:
•
An incoming phone call on your iPhone will mute the music being played.
•
It is possible to leave your iPhone in the docking station to answer the call.
FM radio
•
Press the SOURCE button [E] until the display indicates FM.
•
Extend the antenna [J] for better reception.
•
Shortly press the previous (
and hold for ±3s for auto-scan.
•
To store a radio channel (preset), press the SELECT button. Choose a preset location (01~20) with
the
and
buttons next to the SELECT button to store.
•
To retrieve a preset channel, press the
08.07.2011
; on station: VOL- [F] / VOL+ [G]) to change the settings.
; on station: VOL- [F] / VOL+ [G]).
buttons (next to the SELECT button) to scroll through the menu; press SELECT to
) to play or pause music.
) or next (
) or next (
) or next (
FM9
H standby button (STANDBY)
I snooze button (SNOOZE)
J FM antenna
K battery compartment (2x)
L external input (AUX)
M power switch
N DC input (7.5V)
) or the STANDBY button [H] on the station; the
) button to skip to the previous or next music track.
) button to fast forward or reverse within the track.
) button to adjust radio frequency by 0.1MHz. Press
or
button next to the SELECT button.
5
VOLUME
; on station:
©Velleman nv