Auto-Update - Vieta Home VH-HA042 Manual De Usuario

12/24 Hour display
To change between 12 and 24 hour display, select Set
12/24 hour and then select your preference.
Time/date
The time and date can be updated manually or
automatically. With auto-update, the time and date are
automatically synchronised with external clocks.
Auto-update is generally more accurate.

Auto-update

Auto-update works with data sent over FM or the
Internet.
The clock is only updated when in a corresponding
mode, so it is best to select a mode you use regularly.
FM uses time signals broadcast with radio
transmissions.
Network uses a time signal sent from the Frontier
Silicon Internet radio portal when in any network-
connected mode.
1. Select Update from FM, Update from Network or No
update.
2. If you are updating from the network, set your time
zone.
3. If your country uses daylight saving, the automatically
updated time from the network may be wrong by one
hour. When daylight savings are in effect (during the
winter), turn on the Daylight savings option to rectify
this.
Note that if you are updating the time from FM, the
Daylight savings option has no effect on the clock's
time.
44
VH-HA042 will auto-update from the selected source
when time information is available.
Manual set
If you set No update, the wizard now prompts you to
set the time and date manually.
Network
VH-HA042 is compatible with all common network
protocols and encryption methods, including Wi-Fi
Protected Setup (WPS).
To connect VH-HA042 with your network, you need
one of the following:
• A wired router and an Ethernet (RJ45 network) cable
• A Wi-Fi wireless router, together with password key if
set.
Select WLAN region/country > Wi-Fi network (SSID),
and then select a network from the list.
To connect to a wired network, select Wired, after
ensuring that the Ethernet cable from the wired router
is connected to the Ethernet socket.
If the network is open (non-encrypted), VH-HA042
connects without any further ado; see Completion
below.
Standard encrypted network
To enter the network's key (password), use the Select
control to move the cursor through the characters and
select. As each character is selected, the key is built up
near the top of the display.
There are three options accessible by turning Select
back before the first characters (0123...) – Backspace,
OK and Cancel.
Internet Radio Digital Amplifier