Craftsman 917.248971 Manual De Instrucciones página 6

CONTAINER ASSEMBLY (See Fig. 3)
1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lift top half to
meet bottom half.
3. Press halves tightly together while lifting top to lock
into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES
ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS
SHOWN IN INSET.
4. Repeat for other containers.
CONTAINER
BOTTOM HALF
CONTAINER
TOP HALF
PRESS TOGETHER
TO FORM SEAL
CONTAINER WHILE LIFTING
TOP HALF TOP HALF
CONTAINER
BOTTOM
HALF
LOCKING
TAB
FIG. 3
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
CONTAINER MOUNTING (See Fig. 4)
1. Install one container to left side first with warning to
outside of unit. Install other container to right side.
NOTE: Left edge of right container should always overlap
right edge of left container at center support.
2. Close cover and lock latch handle over center support
tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
CONTAINER
HANDLE
CENTER
SUPPORT
TUBE
FIG. 4
CONTAINER
WARNING
6