Admiral AAW-08CR1FHUE Manual De Uso Y Mantenimiento página 17

WAC 8-24 USER MAN FINAL
OPERATING INSTRUCTIONS
Remote control
2
Mode
9
8
7
Indication symbols of LCD on remote control:
Signal transmit
Auto fan speed
The Above symbols are shown when the relevant mode is in use.
When Changing modes during operation, sometimes the unit does not always respond at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
3/2/05 12:13 PM Page 17
3
High
4
5
6
Auto
1
Cooling Fan only
Low fan speed Medium fan speed
1
BUTTON
The appliance will be started when it is energized
or will be stopped when it is in operation, if you
press this button.
2
Mode BUTTON
Used to select the operation mode.
Each time the Mode button is pressed, the
operation modeis changed in sequence:
COOLING FAN ONLY
3 BUTTONS
Used to set room temperature in COOLING
Used to set room temperature in Cooling
mode or used to set time in TIMER mode.
mode or used to set time in Timer mode.
Temperature setting range is from from
Temperature setting range is from 19 (66 )
19°C (66°F) to 31°C (88°F). to 31 (88 ).
4
High BUTTON
Used to select the
5
Mid BUTTON
Used to select the Mid
6
Low BUTTON
Used to select the Low
7
Auto BUTTON
Used to select the Auto
8
Timer BUTTON
Used to set or cancel timer operation.
9
Saver BUTTON
Used to select the
Energy-saving
High fan speed
15
COOLING
high fan speed mode.
fan speed mode.
fan speed mode.
fan speed mode.
Energy-saving mode.
Display set temp
Display set timer