Publicidad
General safety information
Thank you for choosing a product of SEBSON. Please read
the instructions carefully and keep them for looking up
before start-up this product. A long and failure-free
operation can only be guaranteed if the installation and
start-up is done properly.
Before starting up this product, please check for external
damage. In case of visible external damage we immediately
dis-advise the start-up of this product!
Please remove all packaging material of this product before
the first start-up.
Please read the safety instructions
necessarily.
This lamp is suited for indoor- and
outdoor-use.
A minimum distance from 50 cm from
the light to the illuminated surface has
to be complied.
The light has the protection class 1.
Please connect the yellow/green
protective earth on the network side to
the protective earth terminal.
This product may not be disposed of
with household waste. At the end of its
useful life, the product must be
returned to a point of acceptance for
the recycling of electric and electronic
device.
municipality
acceptance! As the devices contain
valuable recyclable materials, they
should be sent for recycling, in order
not to harm the environment or human
health
disposal.
Scope of delivery:
1 Outdoor light
Screws for fixing (2 pieces)
Dowels (2 pieces)
Washers (2 pieces)
The installation of this light may be done only by a qualified
person according the valid regulations for electrical
installation. Please do not connect a dimmer as this may
cause a damage to the lamp. An exchange of the built-in
luminous in the light is not possible. The remodeling of this
product is not allowed! The manufacture does not accept
any responsibility for injuries or damage resulting from
improper use of the lamp! Any other use than the
description may result in damage to the product. So the
dangers are such as electric shock, short circuit, fire etc.
Please read the safety instructions necessarily! Please
make sure that no flammable objects/materials are kept
near the lamp. This product must never be used in rooms
where flammable gases, vapors or dusts. Before start-up
this product please make sure that the product is protected
from heavy dirt, dampness and warming! In order that the
warranty claim does not expire please use only the supplied
items. Repairs may only be done by an expert and only by
using original spare parts! In commercial institutions, the
accident prevention regulations of the professional trade
association for electrical equipment and facilities must be
adhered to. Caution: In case of damages or contact with
water turn off this product immediately without tension and
Please
ask
your
local
for
the
point
of
from
uncontrolled
waste
SEBSON - Sebastian Sonntag - Gernotstr.17 - 44319 Dortmund Germany - www.sebson.de
make sure that a restart is no longer possible! Do not cover
the light with heat insulating materials. Please read the
safety instructions necessarily. Please keep this product
away from children. Caution: The packaging contains small
parts that can be swallowed by children! Before installing
please make sure that the circuit is interrupted through the
circuit breaker of the fuse box! Check by using a voltage
tester if the line is de-energized. For installation, the work
on the mains voltage is required. Please remove the
associated mains fuse or deactivate the switch fuse! Make
sure that the current circuit will not closed during the
installation!
Cleaning
Caution: Before start cleaning the light please interrupt the
current circuit by switching off the circuit breaker or unscrew
the fuse. Leave the light to cool down at least 10 minutes
before start cleaning! Please do not use solvent-containing
cleaner for cleaning the lamp. Please avoid in cleaning of
the lamp the wearing of metallic or conductive jewelry such
as bracelets, necklaces, rings etc.
CE Declaration of Conformity
This product has been prepared according to the listed below
guidelines.
Low voltage guideline 2014/35/EU
EMV guidline 2014/30/EU
RoHS guidline 2011/65/EU
Allgemeine Sicherheitshinweise
Vielen Dank, dass Sie sich für ein Produkt der Marke
SEBSON entschieden haben. Vor der Inbetriebnahme lesen
Sie sich bitte die Anleitung zur Montage gründlich durch und
bewahren Sie diese zum Nachschlagen auf! Ein langer und
störungsfreier Betrieb kann nur gewährleistet werden, wenn
die Installation und die Inbetriebnahme sachgerecht erfolgt
ist.
Vor der Inbetriebnahme dieses Produkts prüfen Sie dieses
bitte auf äußerliche Schäden. Bei sichtbaren äußerlichen
Beschädigungen wird von der Inbetriebnahme dringend
abgeraten! Entfernen Sie bitte vor der Inbetriebnahme
sämtliche Verpackungsmaterialien.
Bitte beachten Sie vor der Montage der
Leuchte
Sicherheitshinweise und technischen
Angaben!
Dieser Artikel kann im Innen- und
Außenbereich verwendet werden!
Ein Abstand von 50 cm sollte mindestens
zwischen der Leuchte und der Fläche,
die
ausgeleuchtet
eingehalten werden.
Die Leuchte weist die Schutzklasse 1
auf. Bitte schließen sie netzseitig den
gelb/grünen
Schutzerdungsklemme an.
unbedingt
die
werden
soll,
Schutzleiter
an
die
4
Publicidad
