SIZZIX eclips2 Manual De Uso página 5

CAUTION: CUTTING HAZARD Blade is sharp, handle with care.
Safety Cap
Angled
Cutting Edge
Insert this end
into Blade Holder
1
Carefully remove Safety Cap from
Blade, exposing Angled Cutting
Edge.
WARNING: MOVING PARTS Keep fingers, hair and clothing away.
CAUTION: Always unplug Machine before removing or installing Blade Holder.
CAUTION: CUTTING HAZARD Keep fingers away from exposed blade.
1
Lift open Machine Cover to
expose Carriage and Blade
Holder Clamp.
Clamp
Clamp Screw
4
Tighten Blade Holder by turning
the Clamp Screw clockwise, until
Blade Holder is secure.
INSERTING THE BLADE INTO THE BLADE HOLDER
Non-Cutting Side
2
Carefully insert Non-Cutting Side
of Blade into hole at bottom of
Blade Holder. Blade is held in
place magnetically.
INSTALLING THE CUTTING BLADE HOLDER
Rollers
Clamp Screw
Guides
2
Loosen Clamp by turning
Clamp Screw counterclockwise,
approximately 1/4 of a
turn. IMPORTANT: Spring
on end of Clamp Screw
MUST be kept in place.
3
Note that Blade is exposed, but
barely visible, when inserted
properly.
Depth Selection
Arrow
White Ring
Top Edge of Clamp
3
Place Blade Holder into Clamp,
making sure that Depth Selection
Arrow is facing out.
SET UP
5