Napa CARLYLE TOOLS CL800 Manual Del Usuario página 4

6. OPERATING INSTRUCTIONS
6.1 Attach the work light to any ferrous metal surface.
6.2 To adjust the work light to the desired position, slide and swivel the magnetic
mounting brackets.
6.3 Press
button once to turn on at high power.
Press button a second time to turn on at lower power.
Press button a third time to turn the unit off.
6.4 Recharge the work light after use, and at least every 6 months.
7. MAINTENANCE INSTRUCTIONS
7.1 After use and before performing maintenance, unplug and disconnect the work light.
7.2 Use a dry cloth to wipe any dirt or oil from the charging cable and case.
7.3 Ensure that all of the work light's components are in place and in good working
condition.
7.4 Servicing does not require opening the unit, as there are no user-serviceable parts.
7.5 Any servicing should be performed by qualified service personnel.
8. STORAGE INSTRUCTIONS
8.1 Store inside, in a cool, dry place.
8.2 Take care to avoid/prevent damage to the charging cable and unit. Failure to do
so could result in personal injury or property damage.
8.3 Charge the work light's internal battery immediately after purchase, after every
use and every 6 months.
8.4 All batteries are affected by temperature. The ideal storage temperature is at
70°F (21 ˚C). The internal battery will gradually self-discharge (lose power) over
time, especially in warm environments. Leaving the battery in a discharged state
may result in permanent battery damage. To ensure satisfactory performance and
avoid permanent damage, charge the internal battery every 6 months.
9. TROUBLESHOOTING
PROBLEM
The work light does
not operate.
POSSIBLE CAUSE
The battery is not charged. Recharge the battery to full
charge.
• 4 •
V
SOLUTION