Napa CARLYLE TOOLS CL960 Manual Del Usuario página 4

5. CHARGING
IMPORTANT! CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE, AND AT LEAST EVERY 6 MONTHS. Failure to do this will
reduce the battery's capacity and may void the warranty.
5.1 Uncover the micro UBS charging port. Insert the micro USB end of the charging
cable into the micro USB port on the work light.
5.2 Insert the USB end of the cable into the USB port on your charger.
5.3 Plug your charger into a live power source.
5.4 The charge level LEDs will flash green and show the level of charge.
5.5 When the battery is fully charged, all five LEDs will be solid green.
5.6 Disconnect the charging cable from the power source and the work light. Close
the cover on the charging port.
5.7 Recharge the work light after use, and at least every 6 months.
6. OPERATING INSTRUCTIONS
6.1 Hang the work light, using the hook on the end. Pull out the base from the main
body of the work light to rotate 360°, for more precise positioning.
6.2 The magnet may be used instead. Attach the magnetic end of the work light to
any ferrous metal surface.
6.3 Direct the lens away from your eyes before turning on the work light.
6.4 Press the power button once, to turn on the end LED.
6.5 Press the power button a second time, to turn on the four UV LEDs
6.6 Press the power button again, to turn off these LEDs.
6.7 Turn the rotary switch clockwise, to turn on the sixteen SMD LEDs.
6.8 Rotate the switch, to adjust brightness.
6.9 Turn the rotary switch counterclockwise, to turn off the SMD LEDs.
6.10 Recharge the work light after use, and at least every 6 months.
• 4 •
O