Clatronic DB 3108 B Instrucciones De Servicio página 50

• Make sure that the iron voltage (see name plate) and the line voltage match.
• Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
NOTE: Always pull the plug out of the socket after using the iron.
Ironing without steam
1. Empty the water tank if necessary.
2. Place the iron on its stand (9).
3. Sort out the garments according to their ironing temperatures. Start with the lower
temperatures. It is set with the thermostat (1):
„ "
„ "
„
max
4. The control lamp (2) lights up. As soon as it shuts off, the set temperature is reached.
Now you can start to iron.
Steam Ironing
• Steam is produced by means of the steam jet function (3).
• For steam ironing the tank must be full and a high temperature selected, e.g. cotton or
linen.
WARNING: The steam is hot. Danger of scalding!
GB
NOTE:
If you would like to iron subsequently without steam again or at a lower temperature, the
water tank has to be emptied.
Refi lling the water tank
• Always disconnect the mains plug before refi lling water.
• Open the lid of the refi ll inlet (6) and carefully pour in the water. Do not exceed the
maximum line as marked on the water reservoir.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
50
05-DB 3108 B Neu.indd 50 05-DB 3108 B Neu.indd 50
Synthetics, silk
Wool
" Cotton, linen
low temperature
medium temperature
high temperature
maximum temperature
02.12.2008 10:56:46 Uhr 02.12.2008 10:56:46 Uhr