6
Operation
I
NOTE
Before starting your new cooling device for the first time, you
should clean it inside and outside with a damp cloth for
hygienic reasons (please also refer to the chapter "Cleaning
and maintenance" on page 14).
A few water drops may form inside the cooler if it has been
cooling for a lengthy period. This is normal because the mois-
ture in the air condenses to water when the temperature in the
cooler falls. The cooler is not defective. Wipe it out with a dry
cloth if necessary.
6.1
Energy saving tips
Choose a well ventilated location which is protected from direct sunlight.
If you want to set an increased energy efficiency and a limited cooling
capacity for the cooler device, use the device's ECO mode.
Allow warm food to cool down first before placing it in the cooling device
to keep cool.
Do not open the cooling device more often than necessary.
Do not leave the cooling device open for longer than necessary.
12
EN