Operation; Serving; Emptying The Appliance - Buffalo CC190 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Telephone Helpline: 0845 146 2887 (United Kingdom)

Operation

Remove the appliance from the
1.
packaging. Make sure that all protective
plastic film and plastic coatings are
thoroughly removed from all surfaces.
Note: Before using for the first
time, clean the interior of the
appliance and all parts in
warm soapy water, then rinse
thoroughly.
Ensure the Temperature Control knob is
2.
set to '0' and tthe power switch is 'Off'.
Remove the lid and fill the appliance to
3.
at least half of its capacity.
Replace the lid.
4.
Connect to the mains power supply and
5.
turn the power switch On. The Power
Indicator light illuminates.
Set the Temperature Control knob to the
6.
required temperature. The Heat
Indicator illuminates and the appliance
heats the water.
WARNING: Reduce the set temperature if the the water begins to boil. DO NOT allow
the water to boil constantly.
When the water has reached the set temperature the Heat Indicator light turns Off.
7.
Note: Once the water temperature drops 5-10ºC then the appliance will reheat the
water.
WARNING: If the Temperature Control Knob is set to or close to '100' then the appliance
will constantly heat the water until the power switch is turned Off or the temperature
is reduced.

Serving

Place a suitable vessel beneath the tap.
1.
Pull the tap towards you to begin pouring.
2.
Raise the tap handle to close the tap.
3.

Emptying the Appliance

Drain the appliance by using the tap to empty.
On/Off switch
Power Indicator light
UK
Lid
Handle
Tap
Temperature
Control knob
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cc191Cc192Cc193

Tabla de contenido