2) Connect the other end to vehicle cigarette lighter to power and charge the GPS navigators at the same time.
[Caution] Please plug the vehicle adapter after the car is started, avoiding damages to the navigator caused
the instant current at start time.
2.3. Basic Operation
2.3.1. Switching on/off
Please press power key
on the top of the navigator to switch off when you finish application. The system
enters state of dormancy. When you switch on again, the device will maintain the operation status last time you
switch off.
[Note] If you want to save battery energy, you may switch downward the switch to cut off the main power
supply.
2.3.2. Restarting the system
When the system have no response, press power switch key to shut the system and restart the system.
[Reference] The following cases may cause system failure:
1) Delay and stagnation occur while switching over images;
2) Overlong running time fails to activate the click function;
3) Pressing the power key fails to switch on/off the device.
[Caution] If the system fails, you will miss the system information not yet saved by restarting the system. Please
backup the data regularly.
2.3.3. Using the vehicle bracket to fix a navigator
A vehicle bracket is composed of a bracket and a support. Please fix the device using the vehicle bracket onto
the front windshield or dashboard while using the GPS navigator in vehicle.
[Caution] Place the vehicle bracket carefully. Ensure the GPS navigator would not block your driving vision.
Ensure the navigator is fixed instead of being placed randomly. Do not fix it where the air bag is placed. Do not
place it within the bag's inflation range.
2.3.4. Using a touch pen
The touch pen is used to operate the GPS navigator. Please keep it well.
1) Click: Click the screen once with the nib.
2) Double click: Click the screen twice quickly with the nib.
3) Dragging: Click one place with the nib, then, moves the nib.
52
GP033_GP039_manual_hardware_V2_RV1_CV.indb 52
22/09/2014 13:44:00