Emptying The Dust Collector - Siemens VS04G Serie Instrucciones De Uso

en
Vacuuming
9
Figure
Adjusting the floor tool:
a) Rugs and carpets
b) Hard floors
10
Figure
Attach the nozzles to the suction pipe or
handle as required:
a) Crevice nozzle for vacuuming crevices and
corners, etc.
b) Upholstery nozzle for vacuuming upholstered
furniture, curtains, etc.
11
Figure
You can use the parking aid on the back of
the vacuum cleaner if you wish to stop
vacuuming for a short time.
Slide the catch on the floor tool into the
groove at the rear of the appliance.
12
Figure
The appliance can also be carried using the
two handles when vacuuming steps, for
example.
When the work is done
13
Figure
Unplug the vacuum cleaner.
Tug the power cord briefly and let go. The
cable then rewinds automatically.
14
Figure
To store or transport the vacuum cleaner, use
the storage aid on the underside of the
vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide
the catch on the floor tool into the groove on
the underside of the appliance.
You have purchased a floor vacuum cleaner
which can vacuum up any type of dry dirt using
the dust collector or dust bag.
10
We recommend that you use:
- the dust collector, in particular for your
hobbies, e.g. to remove wood shavings, etc.
- the dust bag principally for everyday
household cleaning.
Using the dust collector
15
Figure
Set the power setting to maximum for the
best results when vacuuming.
We recommend that you reduce the setting
only when vacuuming very delicate materials.
!
Attention: The dust bag change indicator
only functions correctly in conjunction
with a dust bag.

Emptying the dust collector

To achieve an optimal result when vacuuming,
the dust collector should be emptied each time
the vacuum cleaner is used.
16
Figure
Turn the dust compartment locking lever in
the direction of the arrow to open the dust
compartment cover.
17
Figure
Remove the dust container from the
appliance.
18
Figure
Release the two snap locks on the bottom
flap in the direction of the arrow, open the
flap until it clicks into the stop position and
the container will then empty the dirt in a
downwards direction.
If the bottom flap is very dirty, (thick dirt)
clean it before closing, by vacuuming it with
the crevice nozzle, for example.
(You must fit the dust bag in the vacuum
cleaner when you do this - see Figure 23)
Close the bottom flap so that it can be heard
snapping into position.