Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DMP8800
7. Level Meters
These meters allow users to view the output signal
levels� There are four LEDs in total, the top of which
indicates whether the output signal is clipping�
8. Meter Button & Input LED
Pushing this button will change the status of the level
meter between that of a pre-DSP input signal level meter
and an output level meter�
9. Phantom Power LEDs
These LED indicators will light up when the corresponding
input's phantom power circuit is activated� Phantom
power itself can be turned on using the Asystems
software�
10. Remote Enable LEDs
When a remote level control is connected and active
for the corresponding channel, this LED will indicate as
such�
11. Enable LEDs
This LED will light up when the corresponding channel is
activated� This is done through the DMP8800 software�
12. Gain Controls
These rotary controls will allow users to adjust the final
input level for channels 1 through 8�
7
9
12

REAR PANEL

13. Ethernet Connection
This connection is for standard RJ-45 cables, used
for 10/100 Ethernet control� Using a CAT5 twisted pair
copper cable, Asystems doesn't recommend a distance
of more than 100 meters to the nearest computer or
hub� The Ethernet connection is used to control the
software via the PC control software and the RM-6E
programmable remote controls�
15 14
English
14. Euroblock Line Inputs
The DMP8800 offers a total of eight line input channels�
These inputs are active balanced with euroblock
connectors� If an unbalanced signal is used, Asystems
advises that customers ground the unused conductor�
15 RCA Line Inputs
These unbalanced RCA connectors are for the
connection of stereo RCA cables� They accompany each
of the eight line input channels mentioned previously�
The stereo signals these inputs receive are summed to
create a mono mix�
16. Line Outputs
The DMP8800 offers a total of eight line outputs� These
are servo-balanced euroblock connectors and can be
wired to either balanced or unbalanced connections�
16
17. Peripheral Connector
This RJ-45 connector is for connecting Asystems remote
peripherals to the DMP8800 series processor�
18. USB Connectors
Two USB connectors have been included on the
DMP8800 for use with a USB mouse – either wired or
8
wireless – and USB flash drives. A USB mouse can be
used to control the internal software without the need
of a computer. The flash drive can be connected when
10
performing firmware updates.
19. VGA Connector
11
This is a standard XVGA connector for use with standard
computer monitors and high definition displays. This will
allow you to control the internal software of the DMP8800
without the need of a computer�
20
13
17
4
19
18
22
21

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Productos relacionados para A SYSTEMS DMP8800

Tabla de contenido