Customizing Room/Bed/Pod Information - Ameda PENGUIN Instrucciones De Uso

4.2 CUSTOMIZING ROOM/BED/POD INFORMATION

FLIP
1. the power switch into the on position.
PRESS HOLD
2. and
Type (Bed, Pod, or Room) will begin flashing on the display screen.
3. To toggle between the Room Type,
change the display words from Bed – Pod – Room – blank.
Note: After 10 seconds, the cursor will stop blinking and the changes will be saved
automatically. The warmer will return to Standby mode. If additional changes are
PRESS
needed after saving,
return to customizing screen.
PRESS
4. the SELECTION button a second time to change the number selection.
5. The number display will begin flashing and
through the numbers from 1 to 999.
scroll quickly. If you need to decrease the number,
to scroll down.
6. To update more locations or numbers. Repeat as indicated above.
SELECTION button.
Note: Additional programming features are available to modify the temperature
settings but should only be changed by a qualified service personnel.
down the SELECTION button. In 3-5 seconds the Room
PRESS
HOLD
and SELECTION button for 3-5 seconds to
PRESS
HOLD
the FROZEN (ice cube) button to
the FROZEN button to scroll
the button down to continuously
PRESS
the WARM/OFF key
PRESS
the
7