Charging The Flight Battery - Estes Dart Manual De Instrucciones

CHARGING THE FLIGHT BATTERY

WARNING!! The charger supplied with the Estes Dart contains
protective circuitry. If you experience any diffi culties while charging the
battery, please disconnect the battery from the charger and unplug the
charger from the power source. Allow the battery and charger to rest for two hours
as this will allow the charge protection circuit to reset.
1.Remove the battery from bottom of the Dart.
2. Plug the USB charger into your USB port. The indicator light will remain off. Plug
the battery into the charger. The indicator light will glow solid, indicating that the
battery is being charged. Once the battery is completely charged, the indicator
light will turn off. Disconnect the battery from the charger. Under normal operating
conditions, the battery may take up to 60 minutes to recharge.
FLIGHT
POWER-ON (FAILSAFE) PROCEDURE
Your Dart is fi tted with a Power-On failsafe. This is designed to ensure that the
motor will not start unless it detects a suitable radio-control signal when the LiPo
battery is connected. The correct Start-Up sequence is as follows:
6